Westell Technologies Versalink 327W User Manual page 105

User Guide
Protocol
Status
IP Address
VersaLink
DNS Primary
DNS Secondary
MRU Negotiation
LCP Echo Disable
LCP Echo Failures
LCP Echo Retry Duration
LCP Echo Retry Duration
Tunneling
NOTE: The values for IP Address, VersaLink, DNS Primary, and DNS Secondary are all "Override of the value
obtained from the PPP connection," They default to "0.0.0.0," in which case the override is ignored. Westell
recommends that you do not change the values unless your Internet Service Provider instructs you to change them.
If you have made any changes to your VC settings, you need to save them. To save the new VC settings, click on
OK when asked Set this PPPoE VC configuration? If you click on cancel, the new VC settings will not be saved.
If you clicked on OK in the preceding pop-up screen, the following pop-up screen will appear. VersaLink must be
reset to allow the new configuration to take effect. Click OK.
030-300408 Rev. B
Possible Responses:
CBR = Constant Bit Rate
UBR = Unspecified Bit Rate
VBR = Variable Bit Rate
The Protocol for each VC, which is specified by your Service Provider.
Possible Responses:
PPPoA = Point to Point Protocol over ATM (Asynchronous Transfer Mode)
PPPoE = Point to Point Protocol over Ethernet
Bridge = Bridge Protocol
Classical IPoA = Internet Protocol over ATM (Asynchronous Transfer Mode). This
is an ATM encapsulation of the IP protocol.
The protocol status.
VC x PPPoE Settings
Displays the IP network address that your modem is on.
Displays VersaLink IP VersaLink address
Provided by your Service Provider
Provided by your Service Provider
Factory Default = DISABLED
If ENABLED, the Maximum Received Unit (MRU) would enforce MRU
negotiations. (NOTE: enable this option only at your Internet Service Provider's
request.)
Factory Default = Enable
If checked, this option will disable the modem LCP Echo transmissions.
Indicates number of continuous LCP echo non-responses received before the PPP
session is terminated.
The interval between LCP Echo transmissions with responses.
The interval between LCP. Echo after no response.
Factory Default = ENABLE
If ENABLED, this option allows PPP traffic to be bridged to the WAN. This feature
allows you to use a PPPoE shim on the host computer to connect to the Internet
Service Provider, by bypassing VersaLink's capability to do this.
NOTE: Tunneling is available in PPPoE mode only.
105
VersaLink™ Gateway (Model 327W)
August 2005