Westell Technologies Versalink 327W User Manual page 123

User Guide
13.6.8 Route
The following settings will be displayed if you select Route from the Advanced WAN menu. The Route table
maintains the routes or paths of where specific types of data shall be routed across a network.
Note: In this screen, VersaLink represents 'Gateway.'
To add a Route, enter a Subnet Mask address, or check the Host Route box. Click on the add button to establish a
static route.
IP Interfaces
Address
Subnet Mask
Name
Network Routing Table
Destination Address
Subnet Mask
VersaLink
030-300408 Rev. B
IP Interfaces
The list of active interfaces on the modem and their IP and Subnet mask address.
Eth0 is the local LAN interface.
Lo0 is the loopback interface.
The IP interface address.
The IP interface subnet address.
The IP interface device name.
Network Routing Table
The list of network routes. These can be either routes for directly connected
interfaces or static routes.
The IP address or subnet of the Route.
If the Route is a network route, Subnet Mask is used to specify the subnet address.
If the Route is a Host route, then the Host Route check box is used.
Indicates were to send the packet if it matches this route.
123
VersaLink™ Gateway (Model 327W)
August 2005