Table of Contents
Advertisement
User Guide
Enable ATM 0/21 Loopback:
13.6.2 WAN Configuration
The following settings will be displayed if you select WAN from the Advanced WAN menu. If you change the
Bridge Broadcast, Bridge Multicast, or Spanning Tree Protocol configurations in this screen, click on the save
filter settings button to allow these changes to take effect. If you change any of the Status configurations, a pop-up
screen will prompt you to reset the Gateway. After the Gateway has been reset, the Status configurations will take
effect. The edit button allows you to change the VC configuration settings of the Gateway. Details on the edit
button are explained later in section 13.6.3.
NOTE: The actual information displayed in this screen may vary, depending on the network connection established.
030-300408 Rev. B
Factory Default = ENABLED
This option enables the 0/21 loopback , which is used by your ISP.
NOTE: Westell does not recommend that you change this setting.
97
VersaLink™ Gateway (Model 327W)
August 2005
Hide quick links:
Advertisement
Table of Contents
