Westell Technologies Versalink 327W User Manual page 14

User Guide VersaLink™ Gateway (Model 327W)
Figure 1. Connection via 10/100 Base-T Ethernet
6.4.2 Connecting PCs via Wireless
IMPORTANT: If you are connecting to VersaLink via a wireless network adapter, the SSID must be the same for
both VersaLink and your PC's wireless network adapter. The default SSID for VersaLink is the serial number of the
unit (located below the bar code on the bottom of the unit and also on the Westell shipping carton). Locate and run
the utility software provided with your PC's Wireless network adapter and enter the SSID value. The PC's wireless
network adapter must be configured with the SSID (in order to communicate with VersaLink) before you begin the
account setup and configuration procedures. Later, for privacy you can change the SSID by following the
procedures outlined in section 13.4 (Wireless Configuration).
NOTE: Client PCs can use any Wireless Fidelity (Wi-Fi) 802.11b/g certified card to communicate with VersaLink.
The Wireless card and VersaLink must use the same Wired Equivalent Privacy (WEP) security code type. The
factory default for WEP is DISABLED. If you enable WEP, you must ensure the network setting for your wireless
adapter is set to "Must Use Shared Key for WEP" or "Open Wi-Fi." You must ensure that your PC's Wi-Fi adapter
is configured properly for whichever network setting you use. You can access the settings in the advanced properties
of the wireless network adapter.
030-300408 Rev. B 14 August 2005