Table of Contents
Advertisement
After the first connection of the telephone, the system begins to load the phone
book from the phone and the SIM card into the memory of the control unit.
Each time the telephone has established a new connection with the hands-free
system, an update of the relevant phone book is performed. The updating can
take a few minutes. During this time the phone book, which was stored after the
last update was completed, is available. Newly stored telephone numbers are only
shown after the updating has ended.
If the number of contacts loaded exceeds 2 500, the phone book is not complete.
If a telephone event (e.g. incoming or outgoing call, dialogue of the voice control)
occurs during the updating procedure, the updating is interrupted. After the tele-
phone event has ended, the updating starts anew.
Connection of the mobile phone with the hands-free system
In order to connect a mobile phone with the hands-free system, it is necessary to
connect the telephone to the hands-free system. Detailed information on this is
provided in the operating instructions of your mobile phone. The following steps
must be carried out for the connection:
®
–
Activate Bluetooth
in your telephone and the visibility of the mobile phone.
–
Switch on the ignition.
Select the menu Phone - Phone search in the information display and wait un-
–
til the control unit has ended the search.
–
Select your mobile phone in the menu of the units found.
Confirm the PIN (as standard 1234).
–
If the hands-free system announces (as standard Skoda UHV) on the display of
–
the mobile phone, enter the PIN (as standard 1234) within 30 seconds and wait
until the connection is established
–
After ending the connection, confirm in the information display that a new
user profile was created.
If no more free space is available for creating a new user profile, delete an existing
user profile.
1)
Some mobile phones have a menu, in which the authorization for establishing a Bluetooth
tion is performed via the input of a code. If the input for the authorization is necessary, it must al-
ways be performed when re-establishing the Bluetooth connection.
Using the system
Safety
1)
.
Driving Tips
General Maintenance
If you have not managed to connect your mobile phone with the hands-free sys-
tem within 3 minutes after switching on the ignition, switch the ignition off and
then again on. The visibility of the hands-free system is established again for 3
minutes. The visibility of the Bluetooth
vehicle starts off or if the mobile phone connects to the device.
During the connecting procedure, no other mobile phone may be connected with
the hands-free system.
Up to four mobile phones can be paired to the hands-free system, whereby only
one mobile phone can communicate with the hands-free system.
Connection with an already paired mobile phone
After switching on the ignition, the connection is automatically established for the
already paired mobile phone
tion was established.
Disconnecting the connection
● By withdrawing the ignition key.
● By disconnecting the device in the information display.
● By disconnecting the mobile phone.
Solving connection problems
If the system announces No paired phone found, check the operating state of the
telephone:
● Is the telephone switched on?
● Is the PIN code entered?
®
● Is Bluetooth
active?
● Is the visibility of the mobile phone active?
● Was the telephone already paired with the hands-free system?
WARNING
In the event of air transport, the Bluetooth
tem must be switched off by a specialist garage!
®
connec-
Breakdown assis-
tance
Communication
®
device is automatically switched off if the
1 )
. Check on the mobile unit if the automatic connec-
®
function of the hands-free sys-
Praktik
Technical data
95
£
Advertisement
Table of Contents
