Table of Contents
Advertisement
Removing the fog light
–
Use the screwdriver to unscrew the screws from the car tool kit
left.
Take out the fog light.
–
Changing the bulb and installing the fog light
Press the locking button
–
1
the socket
B
.
–
Turn the socket
B
with the bulb to the left up to the stop and take it out.
Change the bulb, insert again the socket with the new bulb and turn it to the
–
right up to the stop.
–
Connect the plug
A
to the socket
Screw in the screws again and insert the cover. The cover must engage firmly.
–
Licence plate light
Open the boot lid and unscrew the light glass
–
–
Take the defective bulb out of the holder and insert a new one.
–
Insert the glass cover of the light again and press it down to the stop - ensure
that the sealing rubber is correctly seated.
–
Screw on the light glass slightly.
1)
Valid for Roomster Scout.
Using the system
Safety
⇒ f ig. 158
of the plug
and remove the plug from
A
B
.
Fig. 159 Remove the licence plate light
⇒ f ig.
159.
Driving Tips
Rear light unit
1)
⇒ f ig. 158
-
Fig. 160 Removing the rear light unit/disconnecting the plug connection
–
Open the boot lid/luggage compartment door.
Unscrew the bulb
–
Grasp the light at the top and bottom part and pull it slightly to the rear.
–
–
Disconnect the plug connection
CAUTION
When removing and installing the rear light unit make sure not to damage the
paintwork of the vehicle and the rear light unit.
Changing light bulbs in the rear light unit
Fig. 161 Remove the middle part of the light/Fitting position of the bulbs
General Maintenance
Breakdown assis-
tance
Fuses and light bulbs
⇒ f ig. 160
- left.
⇒ f ig. 160
on the right.
Praktik
187
£
Technical data
Advertisement
Table of Contents
