186
Fuses and light bulbs
Parking light at the front
–
Remove the protective cap
A
–
Grasp the light bulb holder and pull it out of the headlight.
–
Replace the light bulb in the light bulb holder and re-insert into the headlight.
Daylight driving lights and fog lights
Fig. 156 Front bumper: Protective grille/removing the fog light
Switch the ignition and all lights off.
–
Grasp the grille at the points marked with the arrows
–
take it out.
Guide your hand into the opening in which the grille was located and press the
–
⇒ f ig. 156
spring bolt
on the right.
–
Take out the fog light.
Turn the socket
with the bulb for daylight driving light or the socket
–
A
with the bulb of the fog light to the left up to stop and take it out.
–
Replace the lamp, insert the connector with the new lamp and turn to the
right up to the stop.
–
For the installation, first of all insert the fog light with the interlock to the side
far away from the marking of the vehicle.
–
Press into place the headlight onto the side facing the marking.
–
First of all put the grille with the latch in place on the side opposite the mark-
ing.
–
Press into place the protective grille onto the side facing the marking.
⇒ f ig.
or
2
152.
⇒ f ig. 156
on the left and
Cover of fog lights - Roomster Scout
Removing the cover - Roomster Scout
Switch the ignition and all lights off.
–
–
Guide the wire clamp from the vehicle tool kit into the opening above the fog
⇒ f ig. 157
light
and remove the cover.
Fog lights - Roomster Scout
B
Fig. 158 Front bumper: Fog lights/changing the bulb
Fig. 157 Front bumper: Roomster Scout
£