Alarm Data Recording Capacity; Expansion Memory Cards - Sanyo VCC-WB2000P Instruction Manual

Alarm Setting
5
Check and set the sensitivity.
1
Click the [ALARM CHECK] button.
The button will appear green for
approximately 5 seconds. The movement
of objects can only be detected during
this time.
2
When the sensor detects movement,
the ALARM indicator will illuminate
red.
This indicator will disappear momentarily
when the [ALARM CHECK] button is
clicked, and it will illuminate again when
further movement is detected.
3
To set the sensitivity, select a number
(1 to 10) from the MOTION DETECTOR
LEVEL drop-down list box.
After selecting a number, repeat steps 1
and 2 to make sure that the sensitivity is
set to the optimum level.
6
Set the following alarm recording settings
as required.
When an alarm signal is input, the alarm
data is stored in the camera's memory.
•
ALARM BUFFERING "ON"
•
BUFFERING AREA
•
PRIORITY
•
ALARM RESOLUTION
•
OVERWRITE
7
Once you have finished changing the
settings, click the [SET] button.
If an outside intruder comes into the motion
sensor detection area, the ALARM indicator
will illuminate red on the live image screen.
English

Alarm Data Recording Capacity

The capacity of the camera's internal alarm
recording area is approximately 16 MB. The
alarm recording area is divided into the
pre-alarm recording area and the post-alarm
recording area. The pre-alarm and post-alarm
recording area sizes can be set to one of six
settings using the BUFFERING AREA menu
command.
In addition, if an expansion memory card has
been inserted into the PC card slot at the rear of
the camera, alarm data is automatically
recorded onto the memory card from the
camera's alarm memory when an alarm is
received.
A
Inserting the memory card
Check that the memory card is facing the correct
way, and then insert it and slide the knob to lock
it.
B
Removing the memory card
Unlock the card and then press the knob.
A
Note:
•
When inserting and removing the memory
card, make sure that ALARM BUFFERING is
set to "OFF", and then turn off the power.
•
The PC card slot is for 16-bit 5 V cards only.
Do not use 32-bit card bus types of card, as
the terminal sections are different.

Expansion memory cards

•
The memory cards that can be used are
CompactFlash memory cards with a capacity
of 16 MB or greater.
•
The camera does not have a formatting
function. You should format CompactFlash
card memory cards using your computer.
The only format type that can be used is FAT.
– 39 –
ID3
B