Verifying Sm Installation; Installing And Removing The Pvdm4 - Cisco 4451-X Hardware Installation Manual

Chapter 6 Installing and Upgrading Internal Modules and FRUs
Step 6 Check that the SM is installed correctly on the system board.
For more details on installation of SMs, NIMs, and Cisco E-Series Server Modules, please see the
Note
hardware installation guide for the particular module you have purchased.
For a list of links to all the SMs and NIMs supported on the Cisco ISR 4451-X, see the
Roadmap for the Cisco ISR

Verifying SM Installation

Use the show diag command to verify that the SM has been installed correctly. In the following example,
one SM is recognized by the system.
router#show diag ?
all
chassis
slot
subslot
Router#show diag subslot 2/0 eeprom detail
SPA EEPROM data for subslot 2/0:

Installing and Removing the PVDM4

This section describes the installation tasks for the PVDM4 used on the Cisco ISR 4451-X, and it
contains the following subsections:
•
OL-27644-01
4451-X.
All related information
Chassis related information
Slot location information for this command
Subslot location information for this command
EEPROM version
Compatible Type
Controller Type
Hardware Revision
PCB Part Number
Top Assy. Part Number
Board Revision
Deviation Number
Fab Version
PCB Serial Number
Asset ID
Product Identifier (PID) : SM-1T3/E3
Version Identifier (VID) : V01
CLEI Code
Base MAC Address
MAC Address block size
Manufacturing Test Data
Environment Monitor Data : 40 0B E3 43 00 0A
Platform features
Tools and Equipment Required During Installation
: 4
: 0xFF
: 1909
: 1.0
: 73-14154-02
: 800-36532-01
: 06
: 123598
: 02
: FOC15495HU1
: REV 2F
: TBD
: C4 0A CB 56 00 99
: 3
: 00 00 00 00 00 00 00 00
: 02 01 01 0A 00 00 00 00
01 01 00
Hardware Installation Guide for the Cisco 4451-X Integrated Services Router
Installing and Removing the PVDM4
Documentation
6-25