Connecting To A Console Terminal Or Modem; Connecting To The Serial Port With Microsoft Windows - Cisco 4451-X Hardware Installation Manual

Chapter 3 Installing and Connecting the Router

Connecting to a Console Terminal or Modem

The router has asynchronous serial ports and auxiliary ports. These ports provide administrative access
to the router either locally (with a console terminal or a PC) or remotely (with a modem).To configure
the router through the Cisco IOS CLI, you must establish a connection between the router console port
and either a terminal or a PC.
Use the following cables and adapters to establish a local or remote connection.
Table 3-1
Port Type
Serial (RJ-45)
Serial (USB)
Auxiliary (Modem) DB-9-to-DB-25

Connecting to the Serial Port with Microsoft Windows

Note Install the USB device driver before establishing a physical connection between the router and the PC
using the USB Console cable plugged into the USB serial port, otherwise the connection will fail. See
the
Connect the end of the console cable with the RJ-45 connector to the light blue console port on the router.
Step 1
or
Connect a USB 5-pin mini USB Type-B to the USB console port as shown in
the USB serial port for the first time on a Windows-based PC, install the USB driver now according to
the instructions in the following sections.
•
•
•
Note
Step 2 Connect the end of the cable with the DB-9 connector (or USB Type-A) to the terminal or PC. If your
terminal or PC has a console port that does not accommodate a DB-9 connector, you must provide an
appropriate adapter for that port.
To communicate with the router, start a terminal emulator application. This software should be
Step 3
configured with the following parameters:
•
•
OL-27644-01
Local and Remote Connections
Cable
EIA RJ-45
USB 5-pin mini USB Type-B-to-USB
Type-A
"Installing the Cisco Microsoft Windows USB Device Driver" section on page
"Installing the Cisco Microsoft Windows XP USB Driver" section on page 3-17
"Installing the Cisco Microsoft Windows 2000 USB Driver" section on page 3-17
"Installing the Cisco Microsoft Windows Vista USB Driver" section on page 3-17
You cannot use the USB port and the EIA port concurrently. See
Port" section on page
9600 baud
8 data bits
3-19. When the USB port is used it takes priority over the RJ-45 EIA port.
Cisco 4400 Series Hardware Installation Guide

Connecting to a Console Terminal or Modem

Section
Connecting to the Serial Port with
Microsoft Windows
Connecting to the Auxiliary Port
3-16.
Figure 3-8. If you are using
"Connecting to the Auxiliary
3-14