Installing A Compactflash Memory Card - Cisco 4451-X Hardware Installation Manual

Chapter 6 Installing and Upgrading Internal Modules and FRUs
Press the ejector button next to the CompactFlash memory card. The ejector button moves outward so
Step 4
that it projects from the panel.
Press the ejector button again. This ejects the CompactFlash memory card partially out of its slot.
Step 5
Pull the CF memory card out of its slot.
Step 6
Push the ejector button in until the button is flush with the bezel.
Step 7
To prevent damage to the ejector mechanism, the ejector button must remain pressed all the way in (flush
Caution
against the bezel) when not being used to eject a CompactFlash memory card.
Step 8 Replace the fan tray.

Installing a CompactFlash Memory Card

To install a CompactFlash memory card, perform the following steps:
Read the
Step 1
any module replacement.
Remove the fan tray. For instructions on removing the fan tray, see
Step 2
Fan Tray" section on page
Make sure that the ejector button is fully seated until it is flush with the bezel.
Step 3
Note
Insert the CompactFlash memory card into the slot until it is fully seated. The ejector button remains
Step 4
flush with the panel.
Note
To prevent damage to the ejector mechanism, the ejector button must remain fully seated when not being
Caution
used to eject a CompactFlash memory card.
Replace the CompactFlash cover by inserting the cover lip into the chassis and pushing the cover to snap
Step 5
it back into place.
Replace the fan tray.
Step 6
OL-27644-01
"Safety Warnings" section on page 6-2
6-34.
If the ejector button is projecting out from the panel, push it in until it is flush with the bezel.
If the ejector button is projecting from the panel after you insert the CompactFlash memory card,
remove the CompactFlash memory card, press the ejector button until it clicks, and reinsert the
CompactFlash memory card.
Hardware Installation Guide for the Cisco 4451-X Integrated Services Router
Removing and Installing a CompactFlash Memory Card
and disconnect the power supply before you perform
"Replacing the Cisco ISR 4451-X
6-37