Attaching The Cable Guide; Wall-Mounting - Cisco Catalyst 2960 Hardware Installation Manual

Installing the Switch

Attaching the Cable Guide

We recommend that you attach the cable guide to prevent the cables from obscuring the front panel of
the switch and the other devices installed in the rack. Use the supplied black screw shown in
to attach the cable guide to the left or right bracket.
Figure 2-9 Attaching the Cable Guide on the Catalyst 2960 Switch
1
1

Wall-Mounting

This section does not apply to the Catalyst 2960-8TC, 2960G-8TC, and 2960PD-8TT-L switches. For
information applicable to those switches, see
To install the switch on a wall, follow the instructions in these sections:
•
•
•
Catalyst 2960 Switch Hardware Installation Guide
2-12
SYS T
RPS
STA T
DUP LX
SPE ED
MOD E
Cable guide screw
Attaching the Brackets to the Switch for Wall-Mounting, page 2-13
Attaching the RPS Connector Cover, page 2-13
Mounting the Switch on a Wall, page 2-14
Chapter 2 Switch Installation (24- and 48-Port Switches)
Chapter 3, "Switch Installation (8-Port Switches)."
Figure 2-9
OL-7075-05