Mounting The Switch In A Rack; Attaching The Optional Cable Guide - Cisco WS-C3524-PWR-XL-EN Installation Manual

Chapter 2 Installing and Starting Up the Switch

Mounting the Switch in a Rack

Figure 2-5 Mounting the Switch in a Rack

Attaching the Optional Cable Guide

78-6456-04
After the brackets are attached to the switch, use the four supplied number-12
Phillips machine screws to securely attach the brackets to the rack, as shown in
Figure 2-5.
Phillips machine
screws
After the switch is mounted in the rack, attach the power cord to the switch. If you
are using the Cisco RPS, see the Cisco RPS documentation for installation
instructions.
After the power is connected, the System LED turns amber for 2 seconds, and then
it flashes green while the switch completes the series of POST tests described in
the "Powering On the Switch and Running POST" section on page
We recommend attaching the cable guides to prevent the cables from obscuring
the front panel of the switch and the other devices installed in the rack. If the
switch is in a 19-inch or 24-inch rack, use the supplied black screw, as shown in
Figure 2-6, to attach the cable guide to the left or right bracket.
Catalyst 3500 Series XL Hardware Installation Guide
Installing the Switch in a Rack
2-17.
2-13