Mounting The Switch On A Wall - Cisco Catalyst 2960 Hardware Installation Manual

Installing the Switch

Mounting the Switch on a Wall

For the best support of the switch and cables, make sure the switch is attached securely to wall studs or
to a firmly attached plywood mounting backboard. Mount the switch with the front panel facing up, as
shown in
To comply with safety regulations, mount the switches on a wall with the front panel facing up.
Warning
Statement 266
Warning If a redundant power system (RPS) is not connected to the switch, install an RPS connector cover on
the back of the switch. Statement 265
Figure 2-12
1
Catalyst 2960 Switch Hardware Installation Guide
2-14
Figure 2-12.
Mounting the Switch on a Wall
1
User-supplied screws
Chapter 2 Switch Installation (24- and 48-Port Switches)
1
OL-7075-05