Cisco Catalyst 2960 Hardware Installation Manual page 43

Chapter 2 Switch Installation (24- and 48-Port Switches)
Mounting the Switch in a Rack
After the brackets are attached to the switch, use the four supplied number-12 Phillips machine screws
to securely attach the brackets to the rack, as shown in
Figure 2-8
1
After the switch is mounted in the rack, do these tasks to complete the installation:
•
•
•
For configuration instructions about using the command-line interface (CLI) setup program, go to
Appendix C, "Configuring the Switch with the CLI-Based Setup Program."
OL-7075-05
Mounting the Catalyst 2960 Switch in a Rack
SYS T
RPS
STA T
DUP LX
SPE ED
MOD E
1
Phillips machine screws
Power on the switch. See the
Connect to a 10/100 or 10/100/1000 port, and run Express Setup. See the Catalyst 2960 Switch
Getting Started Guide for instructions.
Connect to the front-panel ports. See the
on page 2-18, the "Connecting to SFP Modules" section on page
Dual-Purpose Port" section on page 2-22
Figure
"Verifying Switch Operation" section on page
"Connecting to the 10/100 and 10/100/1000 Ports" section
to complete the installation.
Catalyst 2960 Switch Hardware Installation Guide
Installing the Switch
2-8.
2-7.
2-19, and the "Connecting to a
2-11