Programs Supplied On The Cd; System Requirements; Installing Software; Uninstalling Software - Ricoh SP 3300 Series User Manual

2
Programs supplied on the
CD
The CD-ROM supplied with your printer card provides you with:
• Set IP: A utility program allowing you to select a network printer card
and manually configure the addresses for use with the TCP/IP
protocol.

System requirements

To install SetIP, one of the following operating systems is required:
• Operating system: Windows 2000/XP/Vista/Windows Server 2003,
MAC OS 10.3~10.5

Installing software

1 Insert the supplied CD-ROM into your CD-ROM drive.
The CD-ROM should automatically run, and an installation window
appears.
If the installation window does not appear, click Start > Run. Type
X:\Setup.exe, replacing "X" with the letter which represents your
drive and click OK.
If you use Windows Vista, click Start > All Programs >
Accessories > Run, and type X:\Setup.exe.
If the AutoPlay window appears in Windows Vista, click Run
Setup.exe in Install or run program field, and click Continue in
the User Account Control window.
2 Click Next.
3 Select the language you want.
4 Click Typical installation for a network printer.
5 Follow the onscreen instructions to complete installation.
6 Click Finish when installation is done.

Uninstalling software

You should remove the Network utilities if you are upgrading the software
or if the installation fails.
Note: Close all programs before uninstalling software.
1
2
3
2.1

Programs supplied on the CD

Click Start > Programs > SP 3300 Series > Set IP > Set IP.
Click OK to confirm uninstallation.
Click Finish when uninstallation is done.