Loading The Configuration (Optional); Connecting The Smartnode To The Network - Patton SmartNode 4970 Series User Manual

SmartNode 4970 User Manual
You can check the connection with the ping command from the SmartNode to another host on the network.
172.16.1.99(if-ip)[LAN]#ping <IP Address of the host>

Loading the configuration (optional)

Patton provides a collection of configuration templates on the support page at www.patton.com/smart-
node—one of which may be similar enough to your application that you can use it to speed up configuring the
SmartNode. Simply download the configuration note that matches your application to your PC. Adapt the
configuration as described in the configuration note to your network (remember to modify the IP address) and
copy the modified configuration to a TFTP server. The SmartNode can now load its configuration from this
server.
Note
If your application is unique and not covered by any of Patton's configura-
tion templates, you can manually configure the SmartNode instead of load-
ing a configuration file template. In that case, refer to the SmartNode Series
SmartWare Software Configuration Guide for information on configuring the
SmartNode device.
In this example we assume the TFTP server on the host with the IP address 172.16.1.11 and the configuration
named SN.cfg in the root directory of the TFTP server.
172.16.1.99(if-ip)[WAN]#copy tftp://172.16.1.11/SN.cfg startup-config
Download...100%
172.16.1.99(if-ip)[WAN]#
Loading the configuration (optional)
0 /3
0 /2
0 /1
T 1
/E 1
LAN
LAN (ETH 0/0)
Figure 6. Connecting the SmartNode to the network
0 /0
E T
H
0 /1
C o
n so
le
R S
-2
3 2
4 • Initial configuration
29