Removing And Replacing Batteries - Hoveround MPV4 Owner's Manual

Hoveround.arc 11/2/06
C. Battery Removal/Replacement
Removal
1. Remove each of the battery connectors by pinching the white tab on the
connector at the junction box and gently pulling free (See Fig. 7G, Above).
2. Carefully lift the battery and case clear of the vehicle.
Replacement
1. Either battery can fit onto either side of the vehicle.
2. Place one of the batteries onto the vehicle deck, under the seat, into the
recess of the deck that is provided.
3. Hold the connector of that battery such that the clip is upward.
4. Locate that connector into the appropriate receptacle of the vehicle junction-
box, (left battery connects to the receptacle on the left side).
5. Lock the battery connector plug to the receptacle by pushing until a click is
heard. Gently pull on the connector to ensure it is fully locked in place.
D82008204 REV B 1/14/04
10:07 AM Page 33
Warning! The cable that joins the joystick to the junction
box is a critical part of the vehicle. Ample cable is provided
to allow for adjustments. There is a danger if this cable is
not correctly routed. Do not allow the excess cable to
extend beyond the width of the chair where it may become
damaged.
Figure 7F Figure 7G
Chapter 7 33