Removing And Replacing The Outrigger - Hoveround MPV4 Owner's Manual

Hoveround.arc 11/2/06
D. Outrigger Removal
1. Remove seat as detailed on pages 32-33.
2. Find the retaining hitchpin that protrudes through the outrigger horizontal
tube from the top.
3. Remove that retaining pin.
4. Loosen the socket head cap screw that is located on the outrigger horizontal
corner using the 1/4" hex wrench that is supplied with the vehicle.
5. Pull the outrigger clear of the frame and allow frame to rest on its back edge
(See Figures 7H and 7I, below).
E. Outrigger Replacement
1. Align the male outrigger tube with the female receiver tube that exits
horizontally from the seat post.
2. Mate the two tubes to each other. The outrigger tube should push into the
receiver tube until the holes in the top-face of each are aligned (See Figure 7H).
3. Replace the hitchpin through both members of the outrigger.
4. Tighten the socket head cap screw that is positioned on the corner of the
outrigger horizontal tube, using the 1/4" hex wrench that was supplied
with the vehicle.
34 Chapter 7
10:07 AM Page 34
Figure 7H Figure 7I
D82008204 REV B 1/14/04