Removing And Replacing The Seat - Hoveround MPV4 Owner's Manual

Hoveround.arc 11/2/06
B. Seat Removal/Replacement
Removal
1. Remove controller.
2. Remove the controller cable from the seat clip by pinching the small tabs on
the clip with one hand while removing the strap with your other hand.
(See Fig. 7C, 7D and 7E, Below).
3. Using the 1/4 inch hex wrench supplied with the vehicle, loosen the cap screw
located at the top-front corner of the seat post. (See Fig. 7F, Pg. 33).
4. Grasp the seat at the front and back and lift seat directly upward until it is free
of the seat post.
Clip Location
Figure 7C
Replacement
1. Grasp the seat at the front and back.
2. Align the male post of the seat bracket with the seat post and allow seat
bracket to descend into the seat post.
3. Tighten the socket head cap screw at the top-front corner of the seat post
with the 1/4" hex wrench that is supplied with the vehicle.
4. Reattach the controller cable to the seat by placing the strap around the cable
and inserting the strap into the slot on the clip. Position the cable to the
minimum length to allow the arm to lift. Tighten the strap to keep the cable in
position. To prevent cable damage, do not let the cable hang free or extend
beyond the chair. Use care when driving to keep the cable from catching on
objects.
32 Chapter 7
10:07 AM Page 32
Warning! Seat is heavy. Do not attempt to lift beyond your
capability.
Clip Tabs
Pinch Clip Tabs In As Shown
Figure 7D Figure 7E
D82008204 REV B 1/14/04