Seatback Adjustment - Hoveround MPV4 Owner's Manual

Hoveround.arc 11/2/06
To unlock the seat and swivel 90 degrees in either direction:
1. Locate the swivel release lever positioned at the rear-left underside of the seat,
or front-right side under the seat if so equipped.
2. Release the seat by moving that lever horizontally back if left location, or
horizontally forward if right location.
3. Keeping the lever in the release position, push with your arm or feet to cause
the seat to pivot in the desired direction. Once the seat has moved away from
the locked position, the lever can be released.
Note: Do not use the lever to rotate the seat. Do not force the lever to
the locked position while rotating the seat.
4. Continue to pivot the seat around in the desired direction. When the seat
reaches a 90 degree position, the lever will lock into place to hold the seat in
that position.
Note: Rapid rotation may cause the swivel to skip the locking position.
D. Seatback Adjustment
The standard seat allows some adjustment for back position.
To adjust the back position, locate the recline lever, at the lower right hinge area
(see Figure 4C, Page 25, two different configurations are shown). The seat-back is
spring-loaded and will lurch forward if left unrestrained while the lever is released.
It is best to make adjustments while in the seated position.
Move the spring loaded lever counter clockwise by pulling the lever up or pushing it
back, depending on the configuration on your seat, to release the latch and position
the seat-back until a comfortable position is reached. Release the lever and move the
level clockwise to lock in the position.
24 Chapter 4
10:07 AM Page 24
Warning!
Before attempting to get in to or exit from the seat:
1. Turn the controller off.
2. Check that the seat is firmly locked into position.
D82008204 REV B 1/14/04