Table of Contents
Advertisement
Chapter 1 General Description
4.
Names and Functions of Parts
Names and functions of parts are as follows.
4.1
Front of the server
3.5-inch drive model
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(1) Vent Holes Cover
To take air to cool the server
(2) POWER Switch
The switch to turn the server on and off. Press once to turn
on the server. The LED lights green when it is on. Press it
again to turn off the server. Hold down the switch for 4
seconds or more to forcibly turn off the server.
(3) POWER LED (green/amber)
After the power cord is connected, this LED lights amber
during initialization of system. This LED lights green when
the power is ON.
(4) Disk Access LED (green/amber)
This LED lights or flashes green when the internal hard disk
drive or optical disk drive is being accessed.
The LED lights amber if a hard disk drive error occurs.
(5) STATUS LED (green/amber)
This LED indicates the server status. It lights green when
the server is operating normally.
(6) USB connectors (front)
These connectors are used to connect devices that support
the USB interface.
32
(9)
(7) Front Bezel
This cover protects the front part of the server.
(8) Stabilizer
To mount the server vertically, install as shown in the image
(9) Bezel Lock Tabs (3 at side of Front Bezel)
Tabs to lock Front Bezel to the chassis. Pull toward outside
to disengage Front Bezel.
(10) Optical disk drive
Either of the following drive can be installed.
– DVD-ROM drive
– DVD SuperMULTI drive
Reads data from (or writes data to) the disk.
The drive provides the following: an eject button to eject the
tray; an LED that indicates hard disk drive access; and an
eject hole for forcibly ejecting the tray
(11) 3.5-inch Expansion Bay
The bay which can accommodate 3.5-inch optional device.
Express5800/GT110e-S User's Guide
4. Names and Functions of Parts
Front Bezel removed
(10)
(11)
Advertisement
Table of Contents
