Optical Disk Drive; Replacing Drives; Removal - NEC N8100-1891F User Manual

Chapter 2 Preparations
1.13

Optical Disk Drive

Procedures for replacing the standard optical disk drive with the optional internal DVD SuperMULTI drive are
described below.

Replacing drives

1.13.1
Follow the procedure below to replace your drive with the optional internal DVD SuperMULTI drive.
1. Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. Remove the side cover and front bezel while referring to Chapter 2 (1.4 Removing the Side Cover and
1.5 Removing the Front Bezel).
3. While pressing the latch of the SATA cable,
disconnect the SATA cable from the optical disk
drive.
4. While pressing the stopper which is situated on the
left when you look at from the rear, remove the
optical disk drive from the server.
5. Remove the optical disk drive from the dedicated bracket.
6. Install the DVDSuperMULTI drive to the bracket for optical disk drive from which you removed the
optical disk drive in step 5.
7. Install the bracket with DVDSuperMULTI drive installed to the server.
8. Connect the SATA cable you disconnected in step 4 to the server.
This completes the installation procedures.

Removal

1.13.2
You can remove the optical disk drive by reversing the installation procedure.
98
Important Do not install a drive other than those specified by NEC.
Express5800/GT110e-S User's Guide
1. Installing Internal Optional Devices