Advertisement
MAINTENANCE
Always disconnect power to the machine before
performing maintenance. Failure to do this may
result in serious personal injury.
Cleaning
Cleaning the sliding panel saw is relatively easy.
Vacuum excess wood chips and sawdust, and wipe off
the remaining dust with a dry cloth. If any resin has built
up, use a resin dissolving cleaner to remove it. Treat all
cast iron and unpainted steel with a non-staining
lubricant after cleaning.
Once a week:
Clean sliding panel surface and grooves.
Clean the cast iron or steel plate saw table.
Clean the roller guide ways for the sliding table.
Clean the aluminum rip fence and sliding grooves.
Clean the rip fence bracket.
Once a month:
Vacuum inside the motor cabinet.
Miscellaneous
Always be aware of the condition of your machine.
Routinely check the condition of the following items and
repair or replace as necessary:
Loose mounting bolts.
Worn switch.
Worn or damaged blade.
Worn or damaged blade guard.
V-Belts
To ensure optimum power transmission from the motor
to the blade and to the hydraulic pump, the V-belts must
be in good condition (free from cracks, fraying and
wear) and operate under proper tension. Check the V-
belts at least every 3 months; more often if the saw is
used daily.
Replace the belts, if needed.
Bearings
The bearings are sealed and pre-lubricated and require
no lubrication during their usable life. However, your
saw components will operate at their best if the bearing
surfaces are kept clean this is especially important for
the trunnion bearings.
ELECTRICAL
Main switch
This machine is equipped with a knee touch no-volt
release main switch and a limit switch.
The main switch is equipped a large size touch panel,
during performance cutting work, any part of man body
touched the switch panel, it can bring the saw stop.
Limit switch
The limit switch is mounted under the inner guard, if
your make scoring blade or main blade replacement,
remove the inner guards, the limit switch keep "off"
position. Reduce the risk of unintentional starting.
Thermo cut-out
There is thermo cut-out inside the motor, this device
protect
the
motor
temperature's condition. When the motor's temperature
high
the
fuse
will
should
check
the
temperature or be carried out by qualified specialists at once.
thermo
cut-out
will
automatically once the temperature low down.
from
being
damaged
in
shut
off
automatically,
reasons
to
cause
the
return
to
normal
high
is
too
you
high
The
Advertisement
