Advertisement
ASSEMBLY
Moving & Placing Saw Base Unit
The Sliding Panel Saw is a heavy machine. Serious
personal injury may occur if safe moving methods
are not followed. To be safe, you will need
assistance and power equipment when moving the
shipping crate and removing the machine from the
crate.
Use lifting straps with a minimum of 500 kgs lifting
capacity. If the lifting strap breaks, serious personal
injury may occur.
1. Remove the top of crate and position the forklift forks
together and directly above the saw.
2. Place four lift rings onto Saw Base Unit and place two
lifting straps over the forks and attach the lifting rings
.
3. Insert a wood block for protecting the main switch.
4. Lift the saw base unit and move it to your
predetermined location.
5. Before lowering the saw into position, place four
rubber blocks under the frame.
6. Lower the saw on the floor.
Install the extension table
Take out the cast iron extension table, steel plate
extension table and rear extension table from the Saw
Base Unite crate.
The cast iron extension table is heavy part that
weighs over 35 kgs. To be safer, you will need
assistance.
.
Attach the Cast iron extension table to major table
1
with 4-M8x20 hex head screws/ washers.
.
Center the extension table over the edges and tap it.
2
Check the surface alignment.
3 .Tighten 4-screws with 13 mm open head wrench.
Attach the steel plate extension table to cast iron
extension table, Aligned and tighten them as "install the
cast iron extension table".
Install the sub-support (
1.
Attach the front sub-support to saw base unit and
Tight it with 4-M 10x25 allen screws w/spring washers.
2. Attach the front sub-support to main saw base on
Same way.
3. Align the front sub-support. Rear sub-support and the
Main saw base on the same level.
)
model MJ2600-MJ3200
Advertisement
