Advertisement
Install the rip fence rail
1. insert 4-M10x80 hex head bolts into major table
and extension tables. Loosely attach 2-M10 hex
nuts to each bolt.
2. Screw the four bolts into rip fence rail, just 4-5
circles.
3. First tighten two bolts to align the rail parallel
With the table.
4. Then tighten another two bolts.
Install the rear extension table
1. Attach the rear extension table to the rear portion of
major table with 2-M8x16 hex head screws washers,
hex nuts.
2. Place the bracket onto rear panel of saw base unit
with a M8x16 hex head screw, another end of bracket
mounted to rear extension table with a M8x16 hex
head screw.
3. Align the rear extension 0.5mm lower than the major
table.
Install the main blade elevation & angle
handwheel
1. Fitting the elevation handwheel(1) and angle
handwheel (2) onto the elevation and angle shaft.
2.
Screw the blade lock knob(3) onto the elevation
Handwheel.
Install the swing arm assembly
1 .Place 4 M8x30 hex head screws to mount the swing
arm assembly to the saw base unit, and keep the arm
on horizontal level.
Advertisement
