Advertisement
Install the cross cut fence
1.Drop the cross cut fence into the forward or rear guide
pin hole.
2.Tighten the knurled nut.
3.Turn the "Z" lock plate to quick aligning the fence to
table.
4.Turn the star type screw and clamped the
fence in position.
5.Slide the flip stop(D) into the fence.
6.Place a T-nut into the top slot of fence, thread the
stud of hold-down on fence.
7.If need, put the hold down arm onto the stud (E).
Install the hold down/Mitre Gauge
1. Slide the hold down/Mitre Gauge onto the sliding
table and push it as far as possible. And lock the hold
down/mitre gauge on table with the star-type lock
handle (A) locked.
2. Aligned the Mitre Gauge fence on it.
Install the dust port
Place
the
dust
port
tighten it with 4 M6x12 pan head screws washers and
nuts (nuts inside stand).
Install
the blade guard
The riving knife cuts 3 slot for different blade size.
For PS10 the blade guard mounts to the 254 slot.
For PS12, if using the 254 mm blade place the blade
guard onto 254 slot; if using the 305 or 315 mm place
the blade onto 315 slot.
Install the dust hose support
To install the dust hose support onto the rear portion of
steel
plate
extension
hex
head
screws washers and nuts( nuts under the table).
onto
the
bottom
of
rear panel,
table
with
2
M6x20
Advertisement
