Connecting Wires To Terminals - Kenwood DDX3035BT Instruction Manual

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Connection

Connecting wires to terminals

See page 52.
See page 52.
Connect the antenna
cord to the antenna
terminal.
1
White ª / White with black stripe · : To front speaker (left)
Gray ª / Gray with black stripe · : To front speaker (right)
Green ª / Green with black stripe · : To rear speaker (left)
Purple ª / Purple with black stripe · : To rear speaker (right)
Blue (Antenna control wire)
Blue with white stripe (Power control wire)
Brown (Mute control wire)
Light blue with yellow stripe (Steering remote control wire)
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
See page 52.
See page 52.*
1
(ACC)
(BATT)
(GND)
6
REVERSE
Purple with white stripe
(Reverse sensor wire)
PRK SW
Light green
(Parking sensor wire)
10 A fuse
* 1 Only for DDX3035BT/DDX3035BTM.
* If no connections are made, do not let the cable come out from the tab.
2
Depending on what antenna you are using, connect either to the control
*
2
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type antenna. (Max. 300 mA, 12 V)
When using the optional power amplifier, connect to its power control
terminal.
Connect to the appropriate terminal to enable muting when the phone rings
and during phone calls. (To connect the Kenwood navigation system, consult
your navigation manual.)
To use the steering wheel remote control feature, an exclusive remote adapter
(not supplied) matching your car is required.
To car light control switch
Connect to the vehicle's steering remote harness.
Contact your Kenwood dealer for details.
Connect to the vehicle's reverse lamp harness when
using the optional rear view camera.
Connect to the vehicle's parking
3
brake detection switch harness.
• For best safety, be sure to
connect the parking sensor.
Ignition key switch
To car chassis
Fuse box
Battery
ENGLISH 51