Install The Access Panel; Remove The Media Bay Blank; Remove The Large Redundant Fan Air Baffle - HP ProLiant ML350 G6 User Manual

Install the access panel

Place the access panel on top of the server, allowing it to extend past the rear of the server
1.
approximately 1.5 cm (0.5 in).
Slide the access panel forward until it clicks into place, and close the access panel latch.
2.

Remove the media bay blank

Power down the server (on page 24).
1.
Do one of the following:
2.
Open or remove the tower bezel, as needed
o
Extend the server from the rack (on page 24).
o
CAUTION:
only be maintained when the bays are populated. Unpopulated drive bays can lead to improper
cooling and thermal damage.
Remove the media bay blank.
3.

Remove the large redundant fan air baffle

Power down the server (on page 24).
1.
Do one of the following:
2.
Open or remove the tower bezel, as needed
o
Extend the server from the rack (on page 24).
o
Remove the access panel (on page 26).
3.
Always populate each media bay with either a device or a blank. Proper airflow can
("Open or remove the tower
("Open or remove the tower
bezel" on page 25).
bezel" on page 25).
Operations 27