Install the hard drive.
3.
Determine the status of the drive by observing the drive LEDs
4.
16).
Resume normal server operations.
5.
Hard drive cage options
HP does not support mixing SFF and LFF optional hard drive expansion cages.
Installing a hard drive expansion cage power cable
To install the component:
Power down the server (on page 24).
1.
Do one of the following:
2.
Open or remove the tower bezel, as needed
o
Extend the server from the rack (on page 24).
o
Remove the access panel (on page 26).
3.
Disconnect all cables connected to the system board
4.
("SAS and SATA hard drive
("Open or remove the tower
("System board
components" on page 11).
Hardware options installation 54
LEDs" on page
bezel" on page 25).