Restarting Or Shutting Down The Dvr; Configuring System Warnings; Saving Your System Configuration To A Usb Flash Drive - Lorex LH158 Instruction Manual

7 Right-click until you have exited all menus.
The DVR prompts you to restart.
Restarting or Shutting Down the
DVR
To restart or shut down the DVR:
1 Right-click to open the Menu Bar and click
the Main Menu button (
2 Click Advanced.
3 Click Reboot or Shut Down.
Shut Down
4 Follow the on-screen instructions to
restart or shut down your system.

Configuring System Warnings

The system can send out email
notifications, or trigger a connected
alarm device if it detects system
abnormalities. For example, the system
can send out a warning if the hard drive
is low on storage.
).
Reboot
To configure system warnings:
1 Click the Events tab.
2 Configure the following:
• Event Type: Select the event that triggers
the system to send out a notification or
alarm trigger. Choose from Disk No Space
(low hard drive space), Disk Error (hard
drive error), or Video Loss.
• Enable: Select Enable or Disable to
activate or deactivate the system from
sending out notifications.
• Alarm Out: Select the checkbox to enable
alarm out devices from triggering.
• Show Message: Select the checkbox for
the system to display an error message
when an event occurs.
• Send Email: Select the checkbox for the
system to send out email notifications
when a system error occurs. Note, email
notifications must be configured.
• Latch Time: Select the delay duration in
the drop-down menu.
• Buzzer: Select the buzzer (system beep)
duration when the system detects a
system error.
3 Click Apply to save your settings.
Saving Your System Configuration
to a USB Flash Drive
The DVR allows you to save your current
system configuration to a USB flash
drive (not included). This is useful if you
Using the Main Menu
55