Map Descriptor Example 1 - Sensor / Module Events - FieldServer FS-8700-112 FCI 7100 Series Manual

FS-8700-112 FCI 7100 Series Driver Manual
4.5. Map Descriptor Example 1 – Sensor / Module Events
If messages from Loop 1, Module 1 to 99 are received then the MD in this example will be used for storage. If you have modules on
more than one loop then you will need one MD for each loop. In this example the event type was set to 'Alarm'. This means that
only 'Alarm' events will be stored using this MD. This could be useful if you are only interested I one category of events. If you want
all events stored then change the 'Event Type' to 'Any'.
Example:
F.S.E.C. :[CR][LF]
FIRST ALARM: UP STAIRS N. ENT
// Client Side Map Descriptors
Map_Descriptors
Map_Descriptor_Name, Data_Array_Name,
ModuleData1, DA_MODULE,
It is Tell the driver
recommended the Data Array
that you name
allocate unique starting location
MD names. that data should
be stored.
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com
Manual Station L1M21 00:37:28 01/01/99[CR][LF]
Data_Array_Offset, Function,
0, Passive_Client,
The driver The
listens the
and passively for defined in the
messages from Node
the Panel. It Descriptor
cannot poll for
data.
Page 12 of 24
Event Point Relay/Loop/Zone
Node_Name,
Type, Type, Number,
Panel-01, Alarm, Module 1,
name of
In this example,
Node
only Alarm
events will be
stored.
Messages
reporting other
events will be
ignored unless
other MD's are
defined.
Address, Length, Clear_on_reset
1, 99, Yes,
The
Change this to
specifies
'Sensor' for
starting Module
sensors.
number and the
Length tells the
driver the range
of Modules.
In this example:
Module 1 to 99
address
the