Timing Parameters - FieldServer FS-8700-112 FCI 7100 Series Manual

FS-8700-112 FCI 7100 Series Driver Manual
Column Title
Address
Store As
DA_Bit_Name
Clear on Reset*
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com
Function
This parameter is only considered for those
Map Descriptors whose 'Event Type' is
Module or Sensor.
module or sensor number.
parameter the determines the range of the
sensor/module numbers
By default the driver stores using the 'Index
Value' Method.
Set this parameter to 'Bit' to have the driver
use the primary Data Array to store using the
'Bit Storage' Method.
These methods are described in Appendix
A.3
If the default 'Store As' is specified or if the
parameter is omitted then you can specify a
secondary array using this parameter - the
driver will store event data as 'Bit Storage' in
the secondary array (and as 'Index Values' in
the primary array.)
described in Appendix A.3
If a reset if received you can prevent the
driver resetting the
associated with the Map Descriptor by
specifying this parameter.
It specifies the starting
The length
These methods are
Data Array Points
Page 11 of 24
Legal Values
1..99
Bit, Index_Value
One of the Data
Array names from
"Data Array"
section above
Yes, No