Page 1
Driver Manual (Supplement to the FieldServer Instruction Manual) FS-8700-12 AB DH+ APPLICABILITY & EFFECTIVITY Effective for all systems manufactured after May 2010 A Sierra Monitor Company Driver Version: 1.00 Document Revision:...
FS-8700-12 DH+ Driver Manual ALLEN BRADLEY DH+ DESCRIPTION The DH+ driver allows the FieldServer to transfer data to and from devices using DH+ protocol. Communications Adapter card is included with the FieldServer. The FieldServer can emulate either a Server or Client.
Configure the PLC according to manufacturer’s instructions and configure checksum to use BCC checksum, not CRC. FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com FLASH CONNECTOR B JUMPER...
This section documents and describes the parameters necessary for configuring the FieldServer to communicate with a DH+ Server. The configuration file tells the FieldServer about its interfaces, and the routing of data required. In order to enable the FieldServer for DH+ communications, the driver independent FieldServer buffers need to be declared in the “Data Arrays”...
Not all PLC’s can support all File_Types. Refer to DFS for further information. FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com Page 8 of 16 Legal Values One of the Node names specified in Section 5.3...
Not all PLC’s can support all File_Types. Refer to DFS for further information. FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com Page 12 of 16 Legal Values One of the node names specified in Section 6.3...
Server map 1: N21: 0-31 Server map 2: N21: 32-100 This will panic the FieldServer and crash RS view as the DH+ will attempt to map N21: 0-100. If set up as Server Map 1: N21: 0-100, no problems are experienced.