Map Descriptor Example 1 - Polling All Available Controller Data - FieldServer FS-8700-60 Gardner Denver Instruction Manual

FS-8700-60 Gardner Denver Manual
4.1.4. Map Descriptor Example 1 – Polling all available Controller Data
Map_Descriptor_Name, Data_Array_Name,
GD_MBA1, DA_Service_Data,
GD_MBA2, DA_Oper_Mode,
GD_MBA3, DA_Oper_Data,
Note the active Read Block Continuous map descriptor
function responsible for polling the Controller.
Data will be stored as follows:
Offset Description
0 Advisories
1-20 10x (Shutdown code / Hourmeter reading) pairs
21 Current total runtime hourmeter reading
22 Current loaded runtime hourmeter reading
23-28 6x Current temp hourmeters [H1] – [H6]
29-34 6x Stored temp hourmeters [OH1] – [OH6]
35 Last maintenance A
36 Last maintenance B
37 Oilage
0 Operating mode indication
1 Sequence number
2 Unit operating state
0 System pressure
1 Filter pressure
2 Discharge temperature
3 Reservoir temperature
2
ES V2.0X Controllers do not respond with this field
3
ES V2.0X Controllers do not respond with this field
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com
Data_Array_Offset,
0,
0,
0,
The Gar_cmd field indicates the poll
is for Operating Data.
DA_Service_Data
Operating mode data
2
3
Operating data
Page 8 of 11
Function, Node_Name, Gar_cmd,
RDBC, Node_1, Service_Data,
RDBC, Node_1, Operating_Mode,
RDBC, Node_1, Operating_Data,
Units
see ES/RS2000 Controller spec
see ES/RS2000 Controller spec
Hours
Hours
Hours
Hours
Hours
Hours
Unknown, see ES/RS2000 controller spec
see ES/RS2000 Controller spec
see ES/RS2000 Controller spec
see ES/RS2000 Controller spec
divide by 16 for pressure in psig
divide by 16 for pressure in psig
divide by 16 for temperature in degrees F
divide by 16 for temperature in degrees F
Gar_data, Scan_Interval
All, 1.0s
All, 1.0s
All, 1.0s
The Gar_data field is set to "All"
indicating that all available data is
polled for.