Client Side Connection Descriptors - FieldServer FS-8700-66 GE SNP Manual

Page 9 of 29FS-8700-66_GE-SNP Manual
4.2.

Client Side Connection Descriptors

Section Title
Connections
Column Title
Specify which port the device is
Port
connected to the FieldServer
Protocol Specify protocol used
Baud* Specify baud rate
Parity* Specify parity
Data_Bits* Specify data bits
Stop_Bits* Specify stop bits
Handshaking* Hnadshaking is not supported
Poll _Delay* Time between internal polls
The timeout specified for the connection is used as the data link layer
Timeout timeout. It is also used as the timeout for each Map Descriptor if a timeout
is not explicitly defined for a Map Descriptor.
Example
Client Side Connections
//
Connections
Port, Protocol,
P1, SNP,
GE Port Defaults
Baud
Data Bits
Parity
Stop Bits
Max Link Idle Time
GE Port Capabilities
Baud
Data Bits
Parity
Stop Bits
Max Link Idle Time
1
Not all ports shown are necessarily supported by the hardware. Consult the appropriate Instruction
manual for details of the ports available on specific hardware.
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com
Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: support@fieldServer.com
Function
Baud, Parity,
19200, Odd,
Series 90-30 PLC's
19,200
8
Odd
1
10 Secs
300, 600, 1200, 2400, 4800, 9600, 19200
8
Odd, Even, None
1, 2
1 to 60 Secs
Page 9 of 29
Legal Values
1
P1-P8, R1-R2
SNP
110 – 19200, standard baud rates
only (Vendor limitation), 19200
Even, Odd, None, Mark, Space
7, 8
1
None
0-32000 seconds, 1 second
Handshaking, Poll_Delay
None, 0.100s
Series 90-70 PLC's
19,200
8
Odd
1
5 Secs