Client Side Connection Parameters; Client Side Node Parameters - FieldServer FS-8700-130 Driver Manual

FS-8700-130 Notifier NCA2/NFS-3030 Manual
5.2

Client Side Connection Parameters

Section Title
Connections
Column
Function
Title
Specify which port the device is connected to the
Port
FieldServer
Protocol Specify protocol used
Baud* Specify baud rate
Parity* Specify parity
Data_Bits* Specify data bits
Stop_Bits* Specify stop bits
Example
// Client Side Connections
Connections
Port , Protocol , Baud
P8 , nfs2-nca , 9600
5.3

Client Side Node Parameters

Section Title
Nodes
Column Title Function
Node_Name Provide name for Node
Station address of any physical Node on
Node_ID
network
Protocol Specify protocol used
Specify which port the device is connected
Port
to the FieldServer
Example
// Client Side Nodes
Nodes
Node_Name , Node_ID
Panel_1 , 2
1
Not all ports shown are necessarily supported by the hardware. Consult the appropriate Instruction manual for details of the ports available
on specific hardware.
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-2269 Toll Free: (888) 509-1970 email: support@fieldserver.com
, Stop_Bits , Parity
, 1 , None
, Protocol , Port
, nfs2-nca ,P8
Legal Values
1
P1-P8
nfs2-nca; nca2; nfs2-3030
CRT Port
4800; 9600; 19200; 38400; 57600; (Vendor
limitation)
Printer Port
9600 (Vendor limitation)
None (Vendor limitation)
8 (Vendor limitation)
1 (Vendor limitation)
Legal Values
Up to 32 alphanumeric characters
1-240. Set unique Id for standalone Notifer-
3030 Panel
nfs2-nca or nca2 ; nfs2-3030
P1-P8
Page 9 of 21