Cradlepoint MBR1000 User Manual page 87

CradlePoint MBR1000 | USER MANUAL _ Firmware Version 1.3.1
TOOLS
6.10.3 map SettingS.
By default, when the GPS page reads valid GPS coordinates from the router
it will display the location using an online mapping service in a separate
browser window.
Load Coordinates into Map. (Default: enabled). Disable by un-checking the
check box. Re-enable by checking the
Load Coordinates into map Load
box.
Coordinates into map
Choose Map Provider. The drop down menu enables
Choose Map Provider
you to choose which online mapping service you have the GPS coordinates
sent to. These selections can be saved by clicking the button
Save Settings
GPS screen
at the top of the page.
6.10.4 gpS netWork acceSS.
Enable GPS Network Port. (Default: disabled). The router makes live GPS data available over the local/wireless network. The GPS data can be read
from port 8889 of the router by checking the check box. The GPS data is presented as NMEA 0183 sentences.
Enable GPS Network Port
Enable GPS Network Port on WAN. To get this information into a GPS aware application, you will probably need an extra piece of software that can
bridge the network GPS data into a virtual serial port that the GPS aware application then uses as a GPS device.
NOTE: You may need to enable pop ups in your browser to view the map as it updates.
Table of Contents
PAGE 87