Wireless (Wi-Fi) - Cradlepoint MBR1000 User Manual

CradlePoint MBR1000 | USER MANUAL _ Firmware Version 1.3.1
BASIC

4.6 WireLeSS (Wi-fi).

Use the Wireless (Wi-Fi) sub-menu configure the wireless settings for the
MBR1000. NOTE: Wireless Client settings may also need to be changed if
these settings are modified.
4.6.1 add WireLeSS device With WpS (Wi-fi protected
Setup) Wizard.
Add Wireless Device with WPS. This Wizard helps you add wireless devices
to the wireless network using the Wi-Fi Protected Setup protocol.
The wizard will prompt you to enter the PIN for the device, or ask you to
press the button on the device. If the device supports Wi-Fi
Configuration
Protected Setup and has a configuration button, you can add it to the net-
work by pressing the button on the device and then the
Configuration WPS
button on the router within 60 seconds. The tus LED on the router
WPS sta
will flash three times if the device has been successfully added to the net-
work.
There are several ways to add a wireless device to your network. Access to
the wireless network is controlled by a "registrar." A registrar only allows
devices onto the wireless network if you have entered the PIN, or pressed a
button on the device. The router acts as a registrar
Wi-Fi Protected Setup
for the network, although other devices may act as a registrar as well.
4.6.2 WireLeSS (Wi-fi) netWork SettingS.
Enable Wireless. (Default: Enabled). When checked, wireless connectivity is
enabled.
Require User Login. When checked, users must first login to the router before
getting a full Internet connection.
(continued)
Wireless (Wi-Fi) section
Table of Contents
PAGE 4