Cradlepoint MBR1000 User Manual page 39

CradlePoint MBR1000 | USER MANUAL _ Firmware Version 1.3.1
ADVANCED
5.4.2 add traffic Shaping ruLe.
A Traffic Shaping Rule identifies a specific message flow and assigns a
priority to that flow. For most applications, automatic classification will be
adequate, and specific Traffic Shaping Rules will not be required.
Traffic Shaping supports overlaps between rules, where more than one rule
can match for a specific message flow. If more than one rule is found to
match the rule with the highest priority will be used.
Enable. Specifies whether the entry will be active or inactive.
Name. Create a name for the rule that is meaningful to you.
Priority. The priority of the message flow is entered here -- 1 receives the
highest priority (most urgent) and 255 receives the lowest priority (least
urgent).
Protocol. The protocol used by the messages.
Local IP Range. The rule applies to a flow of messages whose LAN-side IP address falls within the range set here.
Local Port Range. The rule applies to a flow of messages whose LAN-side port number is within the range set here.
Remote IP Range. The rule applies to a flow of messages whose WAN-side IP address falls within the range set here.
Remote Port Range. The rule applies to a flow of messages whose WAN-side port number is within the range set here.
Save. Record the changes you have made.
Clear. Re-initialize this area of the screen, discarding any changes you have made.
When you are done editing the settings, you must click the
(continued)
button at the top of the page to make the changes effective and permanent.
Save Settings
PAGE 3
Add Traffic Shaping Rule section
Table of Contents