Connecting Network; Connecting Rs-485 Device - LG LE5008 Series Owner's Manual

16 Installation

Connecting Network

You can control and monitor the system via network. With
the remote control (monitoring), you can change the system
configuration or monitors the image via network. After the
installation, check the network settings for the remote control and
monitoring work.
Network connection
3
LAN connection
Connect the LAN port to an available 10/100/1000 base-T port with
a straight ethernet cable (not supplied). The NET indicator on the
front panel will be lit.
IP Camera connection
Connect the IP camera. After the installation, check the IP camera
settings on the setup menu.
Automatic network configuration
The DVR can automatically obtain and configure the network
interface via DHCP.
Manually configure network
The DVR may be manually configured by assigning an IP address,
subnet mask, gateway and DNS.

Connecting RS-485 device

This DVR has two data terminals. Use this port to connect PTZ
cameras, DVRs or keypads (optional).
RS-485 Terminal
D - (DATA -)
D + (DATA +)
GND
Broadband
Router
Service
Description
Data Transmission/Reception
Data Transmission/Reception
Shield
Connecting the PTZ device
Connecting the PTZ serial communication lines to the
RS-485 terminal.
PTZ device connection
5~7 mm
PTZ units
(RS-485 type)
NOTE
• When connecting lines, connect the "D -" of the DVR to "RX -"
of the PTZ unit and "D +" of the DVR to "RX +" of the PTZ unit
correctly.
• Recommended initial data are 9600 Baud Rate, 8 Data bits,
1 Stop bit and No parity.
• When connecting PTZ cameras to DVRs it is necessary to set
the setup menu for this unit according to the RS-485 settings
of the camera and DVRs.
PTZ units
(RS-485 type)