Device settings
Camera
•
Channel: Select the channel number.
•
Channel Name: Enter the channel name using up to 20
characters.
•
Audio: Select the input audio channel. You can hear from the
selected input audio channel. This function is not available for IP
channels.
IP Camera
•
Channel: Selects the desired channel to set the connected IP
camera.
•
Vendor: Selects the IP camera vendor from the drop-down list.
•
Model Name: Enter the model name of the IP camera.
•
Host Name: Enter the IP address of the IP camera.
•
User Name: Enter the user ID.
•
Password: Enter the user password.
•
Port: Enter the port number.
ATM/POS Setting
•
Interface Device: Select the interface device from the drop-
down list.
•
Camera: Select the camera number for mapping with ATM/POS
device.
•
Baud Rate: Select the desired parameter to set the
communication speed between DVR and ATM/POS device.
•
Data Bits: Select the number of the data bits for RS-485
communication.
•
Stop Bits: Select the desired parameter. The stop bit, added to
the last of data, in asynchronous communication.
•
Parity: Select the desired parameter. The parity bit, added to the
data, to perform parity check.
Storage
•
Overwrite:
-
All: Overwrite recording is possible when the normal
partition and event partition of HDD have fully recorded.
-
Normal Partition: Overwrite recording is possible for normal
partition of HDD when the normal partition of HDD has fully
recorded.
-
Event Partition: Overwrite recording is possible for event
partition of HDD when the event partition of HDD has fully
recorded.
-
Off: Do not use overwriting.
•
Full Warning: When the HDD has overflowed a warning message
is displayed.
•
Auto Delete: Set the auto delete date. If you set the auto delete
date, the recorded data will be deleted except the data within
the selected date period of time. The Auto Delete function is
activated every 35 minutes.
•
Event Partition: This option setting is not available in the client
program.
Display settings
•
Channel: Selects the desired channel to adjust.
Channel Composition
•
Name: Selects the desired channel.
PTZ
Settings for the PTZ cameras connected via the data port of the
RS-485 terminal.
•
Port: Selects the connected data port of the RS-485 terminal
on the rear panel. The DATA 2 port is used to control the PTZ
camera connected to DVR or to control by using the LKD1000
controller. If you want to use the PTZ camera via DATA 2 port,
you should set the [Remote Controller ID] to [NONE]. If you use
the LKD1000 controller to control the DVR via DATA 2 port, you
should set the [Remote Controller ID] number between 1 to 16.
•
Control ID: Selects the PTZ camera ID. Make the same settings
as the PTZ camera.
•
Protocol: Selects the protocol supported by PTZ camera.
•
Baud Rate: Selects the communication speed.
Video Adjustment
Adjust the brightness, contrast and color settings of each camera
channel. You can see the settings screen from the preview windows.
•
Brightness: Adjust the brightness value from 0 to 100 for the
selected channel.
•
Contrast: Adjust the contrast value from 0 to 100 for the selected
channel.c
•
Color: Adjust the color value from 0 to 100 for the selected
channel.
LG Network Client Program
57
5