Konica Minolta 7222 User Manual page 211

Copying Image in the Center of Copy Paper (AUTO Layout) (continued)
• Non-Image Area Erase will be selected automatically.
• When using the Book Copy with this function, an original smaller than the
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select the desired magnification and paper size on the Basic Screen.
• APS and AMS are automatically released, and 1.00 (100%) is selected as a
• Copy mode is automatically set to 1-1. When selecting 1-2 mode, Platen
5.
Enter the desired print quantity from the control panel keypad.
See p. 3-7 for details on setting print quantity.
6.
Position original FACE DOWN on the platen glass.
For details on positioning originals, see p. 3-5 to p. 3-6.
DO NOT close the RADF or platen cover when Non-Image Area Erase is
selected.
Placing original obliquely on the platen glass may cause black copy marks.
7.
Press [START].
When the finisher / inner / paper exit tray capacity is exceeded due to
the print quantity selected, remove the copied sets as they exit;
otherwise, mishandled paper will occur.
The AUTO layout function may not operate properly if lighting is directly over
the platen glass. In this case, consult your service representative about an
appropriate place for installation.
selected paper size will be printed in the center of the copy paper without
image division performed.
magnification ratio.
store mode will function automatically.
Application
Selection Screen
Sheet/Cover
Insertion
Chapter
Combination
Booklet
Transparency
Image Insert
Book Copy
Upside Down
Non-Image
Area Erase
Reverse
Image
Repeat
Frame/Fold
Erasure
AUTO
Layout
9
Applications
Image Shift
Reduce &
Shift
Stamp
Overlay
9-41