Konica Minolta 7222 User Manual page 198

Erasing Outside of the Original (Non-Image Area Erase) (continued)
3.
Touch OK on the Application Selection Screen.
The Basic Screen will be restored.
4.
Select magnification and paper size, as desired.
5.
Enter the desired print quantity from the control panel keypad.
6.
Position original FACE DOWN on the platen glass.
7.
Press [START].
9-28
• APS and AMS are automatically released.
• Copy mode is automatically set to 1-1. When selecting 1-2 mode, Platen
store mode will function automatically.
See p. 3-7 for details on setting print quantity.
DO NOT CLOSE THE DOCUMENT FEEDER OR PLATEN COVER.
Original size should be larger than 10 mm x 10 mm.
Oblique Erase and Rectangle Erase Modes
The Non-image area erase has two modes; Rectangle erase mode and
Oblique erase mode. The copier is initially set to Oblique erase mode.
If copy result is not satisfactory in the initial setting, ask Key Operator to select
the Rectangle erase mode, or to specify the original density level to obtain the
optimum copy effect. See p. 13-13.
Oblique erase mode
This function may perform incorrectly if lighting is directly over the platen glass.
In this case, consult your service representative about an appropriate place for
installation.
Rectangle erase mode