D-Link xStack DGS-3400 Series User Manual page 176

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
To establish the rule for a previously created Access Profile:
To configure the Access Rule for Ethernet, open the Access Profile Table and click Modify for an Ethernet entry. This will
open the following screen:
To remove a previously created rule, select it and click the
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameter Description
Profile ID This is the identifier number for this profile set.
Mode Select Permit to specify that the packets that match the access profile are forwarded by the
Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not forwarded by the
Switch and will be filtered.
Access ID Type in a unique identifier number for this access. This value can be set from 1 - 128.
Auto Assign – Checking this field will instruct the Switch to automatically assign an Access ID
for the rule being created.
Selected profile based on Ethernet (MAC Address), IP address or IPv6 address
Type
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
IP instructs the Switch to examine the IP address in each frame's header.
IPv6 instructs the Switch to examine the IPv6 address in each frame's header.
Priority (0-7) This parameter is to be specified to re-write the 802.1p default priority previously set in the
S it h
Figure 8- 9. Access Rule Table
Figure 8- 10. Access Rule Configuration window - Ethernet
hi h i d t d t
button. To add a new Access Rule, click the Add Rule button:
i th C S t
162
hi h k t f d d t O thi