Poe Port Settings - D-Link xStack DGS-3400 Series User Manual

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch

PoE Port Settings

The following window will allow the user to configure PoE settings for each port of the device. To open this window, click
Administration > PoE System > PoE Port Settings.
The following parameters may be configured or modified for PoE Ports.
Parameter Description
Choose the switch in the switch stack for which to configure the PoE port settings.
Unit
Users should note that not all switches in the xStack DGS-3400 series support PoE yet, when
they are configured in a stack, the Primary Master switch will display the PoE settings to be
configured for the stack, whether or not the Switch is a PoE supported device. However, only
PoE supported switches have the PoE capability in the switch stack.
From... To... Select a range of ports from the pull-down menus to be enabled or disabled for PoE.
State Use the pull-down menu to enable or disable ports for PoE.
Priority Use the pull-down menu to select the priority of the PoE ports. There are three levels of priority,
Critical, which is the highest, High and Low. The priority level will affect the order of supplying
power to ports. This priority also affects the disconnect method of PoE ports when the Deny Low
Priority option is chosen, and ports with a higher priority will take power precedence over low
priority ports.
Power Limit Sets the power limit per PoE port based on Class as described above. Once this threshold has
been reached on the port, the PoE will go into the Power Disconnect Method, as described
above. The user may alternatively set a limit between 1000 and 16800mW by clicking the User
Define check box and manually entering a power limit in mW.
Click Apply to implement changes made. The port status of all PoE configured ports is displayed in the table in the bottom half of
the screen above.
Figure 6- 70. PoE Port Settings and Port Table window
96