Ipv6 Interface Settings - D-Link xStack DGS-3400 Series User Manual

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Parameter
Interface Name
IP Address
Subnet Mask
VLAN Name
Interface Admin. State
Click Apply to implement changes made.

IPv6 Interface Settings

The following window is used to setup IPv6 interfaces and addresses for the switch. To access this window, open the Interface
Settings link and click the IPv6 Interface Settings link, which will display the following window to configure.
To add a new IPv6 interface, click the Add button which will display the following window.
To add an Interface, enter an Interface Name in the field provided, along with a corresponding VLAN Name, set the Interface
Admin. State to Enabled and click Apply. Newly created interfaces will appear in the IPv6 Interface Settings window, as shown
in Figure 6-4 (Triton).
To change the settings for a configured Interface, click the corresponding Modify button, which will display the following
window for the user to configure.
Description
This field displays the name for the IP interface or is used to add a new interface to be
created by the user. The default IP interface is named "System".
This field allows the entry of an IPv4 address to be assigned to this IP interface.
This field allows the entry of a subnet mask to be applied to this IP interface.
This field states the VLAN Name directly associated with this interface.
Use the pull-down menu to enable or disable configuration on this interface.
NOTE: The Switch's factory default IP address is 10.90.90.90 with a
subnet mask of 255.0.0.0 and a default gateway of 0.0.0.0.
Figure 6- 6. IPv6 Interface Settings window
Figure 6- 7. IPv6 Interface Settings – Add
42