Multiple Image Services; Firmware Information - D-Link xStack DGS-3400 Series User Manual

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch

Multiple Image Services

The Multiple Image Services folder allows users of the Switch to configure and view information regarding firmware located on
the Switch. The Switch allows two firmware images to be stored in its memory and either can be configured to be the boot up
firmware for the Switch. For information regarding firmware images located on the Switch, open the Firmware Information
link. The default setting for the Switch's firmware will have the boot up firmware stored in Image 1, but the user may set either
firmware stored to be the boot up firmware by using the Config Firmware Image menu.

Firmware Information

The following screen allows the user to view
information about current firmware images
stored on the Switch. To access the following
screen, click Administration > Multiple
Image Services > Firmware Information.
This window holds the following information:
Parameter Description
ID States the image ID number of the firmware in the Switch's memory. The Switch can store 2
firmware images for use. Image ID 1 will be the default boot up firmware for the Switch unless
otherwise configured by the user.
Version States the firmware version.
Size States the size of the corresponding firmware, in bytes.
Update Time States the specific time the firmware version was downloaded to the Switch.
From States the IP address of the origin of the firmware. There are five ways firmware may be
downloaded to the Switch. Boot Up files are denoted by an asterisk (*) next to the file.
R – If the IP address has this letter attached to it, it denotes a firmware upgrade through the
Console Serial Port (RS-232).
T - If the IP address has this letter attached to it, it denotes a firmware upgrade through Telnet.
S - If the IP address has this letter attached to it, it denotes a firmware upgrade through the
Simple Network Management Protocol (SNMP).
W - If the IP address has this letter attached to it, it denotes a firmware upgrade through the web-
based management interface.
SIM – If the IP address has this letter attached to it, it denotes a firmware upgrade through the
Single IP Management feature.
User States the user who downloaded the firmware. This field may read "Anonymous" or "Unknown"
for users that are not identified.
Figure 6- 29. Firmware Information window
63