Rear Panel - Yamaha PJP-EC200 User Manual

Rear panel

AUTO
ANALYZER
INITIALIZE
PHANTOM
DIP SW
ACTIVE
1
AUTO ANALYZER
Press this switch to adjust the echo canceller and feedback
suppressor automatically.
2
INITIALIZE
If you turn on this unit while holding down this switch,
you can reset the settings of this unit to the default. If you
press this switch when the power is on, only the network
settings are reset to the default. For details, refer to
"Resetting the Settings of This Unit" (page 56)".
3
LED (PHANTOM)
Lights to indicate the status of the phantom power.
• On: The phantom power is on.
• Off: The phantom power is off.
• Blinks: The setting is not reflected.
y
• If the setting is not reflected, refer to "Q1: LEDs are off
or blinking" (page 51)".
• This LED works in the same way as the PHANTOM
LED on the front panel.
4
DIP switch
Changes the settings of this unit.
5
LED (DIP SW)
Lights to indicate the prioritized settings (DIP switch or
web menu).
• On: The DIP switch settings are prioritized.
• Off: The web menu settings are prioritized.
• Blinks: The setting is not reflected.
y
• If the setting is not reflected, refer to "Q1: LEDs are off
or blinking" (page 51).
• This LED works in the same way as the DIP SW LED
on the front panel.
ETHER LINE OUTPUT CONFERENCE
R L OUT IN
ACTIVE
MIC/LINE INPUT
IN2 IN1
GAIN
MIN MAX MIN MAX
IN2 IN1
6
ETHER
Use to connect a LAN cable. The LINK LED (left) and the
SPEED LED (right) are above the LAN port.
• LINK LED: Off (no link), On (linked), Blinks
(during data transfer)
• SPEED LED: Off (10BASE-T), On (100BASE-TX)
7
LINE OUTPUT (L/R)
Use to connect speakers with built-in amplifier, or a PA
system.
y
These jacks output monaural audio signals only.
8
CONFERENCE (IN/OUT)
Use to connect a PC or a videoconference system.
9
GAIN (IN1/IN2)
Adjust the input gain for MIC/LINE INPUT.
0
MIC/LINE INPUT (IN1/IN2)
Use to connect a microphone or a PA system. In addition,
these jacks can be used as the XLR or PHONE jacks.
• XLR jack
Balanced input jack (1: Ground, 2: Hot, 3: Cold)
• PHONE jack
Monaural unbalanced input jack. (TS PHONE jack)
A
DC IN 12V
Use to connect the supplied AC adapter.
B
Power switch
Turns on or off this unit.
STANDBY ON
DC IN 12V
9