Resetting The Settings Of This Unit; Resetting All Settings; Resetting The Network Settings - Yamaha PJP-EC200 User Manual

Resetting all settings

You can reset the web menu settings and settings internally saved in this unit to the default.
Notes
Please note the followings when you reset the settings of this unit.
• This operation will disconnect all the calls being connected.
• This operation will restore the factory default values (if available).
• This operation will overwrite data stored in the nonvolatile memory.
• You cannot undo the reset operation.
■Initializing using the web menu
1
In the web menu, click "Maintenance"
and then click "Execute" in the [Special
Functions] - [Recover Initial Settings]
field.
2
Click "Apply".
The confirmation screen appears.
3
Click "Close".
The settings of this unit are reset to the default. Since
the configurations you have made are all cleared, you
need to reconfigure this unit.

Resetting the network settings

In case that you cannot access the web menu (setting an incorrect IP address, etc.), follow the procedure below to reset
the network settings of this unit.
Note
This operation will reset "LAN Port Settings", "Default Gateway Settings" and "DNS Server Settings".
1
Turn on this unit.
2
After this unit is started, press
INITIALIZE.
Since the button is located inside the small hole, use a
ballpoint pen or similar object to press the button.
The front LEDs blink several times.
56

Resetting the Settings of This Unit

■Initializing using the button on the main
unit
1
Turn off this unit.
You do not need to disconnect cables.
2
While holding down INITIALIZE, turn on
this unit.
Since the button is located inside the small hole, use a
ballpoint pen or similar object to press the button.
The front LEDs blink several times.
3
3 Release INITIALIZE.
The settings of this unit are reset to the default. Since
the configurations you have made are all cleared, you
need to reconfigure this unit.
3
Release INITIALIZE.
The network settings (IP address, etc) of this unit are
reset to the default.